Stop! Do not proceed until the Status LED is solid blue, indicating activation on your provider's network.
- Insert your vehicle's ignition key and turn it to the on position (not ACC/Accessory). Do not start the engine!
- Typically, all of the warning lamps on the dashboard will illuminate briefly in this position - For pushbutton-start vehicles, the procedure is typically to push the start button without your foot on the brake (check your vehicle owner's manual to determine how many presses are required to turn the ignition on).
- Press and hold the Function Button on the side of the Delphi Connect module until the Status LED blinks red one time. This will occur after approximately 5 seconds. Then release the Function Button. The LED will blink red while vehicle setup occurs.
- Wait up to 30 seconds for the LED to display a mix of solid and blinking green.
- Wait an additional 10 seconds for the LED to go out.
- When the LED begins to flash blue every 10 seconds, setup is complete.
Stop! Do not proceed if the Status LED never turned green and returned to solid blue. Your vehicle may not be compatible with the Delphi Connect module (check our fitment guide at delphiconnect.com/fitment) or you did not place the ignition in the on position.